Pre-1980 Vintage Skateboard Gear

Posts 5453-5477 of 6027

Pre-1980 Vintage Gear (6027 Posts) Product Info a few of the kids On 9/3/2008 cabowabo44 wrote in from United States  (130.134.nnn.nnn)     Rate post 307430 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) My Favorite Skateboard On 9/3/2008 Ron wrote in from United States  (71.107.nnn.nnn)     Rate post 307427 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Yum Yum Good! On 9/3/2008 Ron wrote in from United States  (71.107.nnn.nnn)     Rate post 307426 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Pics On 9/3/2008 caddy wrote in from United States  (206.135.nnn.nnn) Nice!     Rate post 307422 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Mark Baker Megatrons On 9/2/2008 Shaun wrote in from United Kingdom  (82.6.nnn.nnn) Curt I have a set of these but was not intending on parting with them. I can let you have some pics if you like. I may be willing to trade. I know they are rare as i have never seen another set for sale anywhere. Shaun     Rate post 307408 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Mad Mark Baker On 9/2/2008 Curt wrote in from United Kingdom  (91.109.nnn.nnn) Hey, I am always keen to reunite with a pair of Mark Baker Megatron Trucks. I am from Baker's home Town and saw him skate for a few years! Any clues? Please pass on...     Rate post 307406 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Thanks On 8/31/2008 Nathan Fisher wrote in from Japan  (61.44.nnn.nnn) Thanks for the encouragement! I will do my best. I already purchased two sets of hangers for the one unbroken plate so I will have to keep an eye out.     Rate post 307355 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Unbroken Bennett Trucks On 8/31/2008 Vintage man wrote in from United States  (66.245.nnn.nnn) Its not that hard to find.... Its not easy, but not impossible... Ohayou Nathan from Japan.... At least 6 sets have come up on ebay in 2008 complete with NON BROKEN OR SPLIT Bennett Plastic baseplates.... Depending on condition of hangers, figure $100-$150 minimum for Hijackers and Bennett Pros... If minty a set of Bennett Pros went for $250-ish approx in April. Sometimes the best way is to look for skateboards with the Bennett Trucks on them... Maybe mix and match, then sell your extras!! Finding ONLY THE PLASTIC BASEPLATES is very difficult, if not near impossible... Again, look on ebay, ask in the Buy Sell Trade page of this site, I have found to be the best ways... I posted before, enjoy the attached...Oh, I mixed and matched to get these completed with unbroken plates THIS YEAR IN 2008.... Did by using ebay and this ncdsa.com site... Did it over 6 months. WAS NOT THAT DIFFICULT... Heck these pictures were taken about 90 days ago and are not even my final version where I have NOS Bennett Pro Hangers, bushings, etc that were up few weeks ago and I also have on them the NOS re-issue bennett chrome nuts and spacers UP NOW ON EBAY!! I need to update my pictures!     Rate post 307350 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Bennett Baseplates On 8/31/2008 Harvey wrote in from United Kingdom  (81.155.nnn.nnn) Unbroken / uncracked Bennett Baseplates? Man, you don't ask for much do you!? I've had loads of Hijackers and Pros over the years and have yet to find any that are completely 'virgo intacta' Good luck Bro! ; )     Rate post 307349 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Bennett Baseplate On 8/31/2008 Nathan Fisher wrote in from Japan  (61.44.nnn.nnn) Does anyone have a single or pair of unbroken/uncracked BENNETT baseplates? THANKS     Rate post 307347 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Dick Brewer On 8/30/2008 Ron wrote in from United States  (71.107.nnn.nnn) The Brewer setup has Dick Brewer XL-3000 trucks with grey bushings ... also two Brewer XK-300 and two XK-400 wheels. Shown exactly as I got it... oh yeah... one red and one black Rad Pad too. Cheers, Ron wats168     Rate post 307334 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Set up for a Blizzard Frrestyle Board On 8/30/2008 Dennis Allgeier wrote in from United States  (71.125.nnn.nnn) Hey-does anyone out there have any idea as to how an Austrian Blizzard Frestyle board may have been set up? I am not sure from what time period it is from but the top deck is black, white and Green and says Freestyle on it and the bottom is all black with the name BLIZZARD in larger white letters and made in Austria in smaller white letters below that. I would appreciate any info anyone can give me on the background of this board and what trucks and wheels may have been used to set it up since it is a free Style board. Thanks; Dennis     Rate post 307331 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) trucks on brewer board On 8/30/2008 buddy rawls wrote in from United States  (205.188.nnn.nnn) I bought a Brewer for my Bro in law a couple of years ago. I cannot determine by the photo below if those are brewer trucks or not. BUT I can tell you that the Brewers on my bro-in-law' board were original and untouched, and they had the grey rubbers that look very much like the ones on the board below in the photos. Without any differing evidence, and the fact it is a Brewer deck, I would say with about 80% surety that they are Brewer trucks. I will try to snag some photos of his Brewer trucks.     Rate post 307317 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) april 76 On 8/30/2008 herbn wrote in from United States  (71.127.nnn.nnn) skateboarder magazine the covers gone but the inside page with the cover date is still attached. There's a very early ad for speedspring trucks an all black version with "new improved molded baseplate" meaning there was an earlier version,yandall in the roadrider ads with hester ect. russ howell handstanding off a curb very close to knuckle disaster,aligators in loose and sealed bearings,tom sims in the santa barbra bowls,starving alva in hawaii nosewheeling stoker in boatshoe slipons....     Rate post 307309 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) brewer xl 3000's On 8/30/2008 herbn wrote in from United States  (71.127.nnn.nnn) just a few pages in on one of my most vintage of magszines,pre phantom,loose bearing, but the shape of the hole pattern is right and there's a matching weight saving depression on other side of the hanger on the way to the pivot.     Rate post 307308 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) Herbin observations On 8/29/2008 Vintage Man wrote in from United States  (192.193.nnn.nnn) Me, I just like the colors :------) Herbin, send your email address to me, and I will forward to said collector.... Heck you might even know him... Maybe he can answer the in's the out's the what have you's of his specific set ups. He is not as big a chatty cathy as I, but might provide you with a lot of the in's the out's the what have you's of his set ups.(in's out's what have you's quote from Big Lebowski :-) I do know, most were purchased and you see as is. Usually C7+ or better condition, he gets really nice stuff... If no interest, I will not see a reply from ya :---) eees ok.... Have a great Labor Day..Hummm, Labor Day is a day of NO Labor.... Driveway, we park on, no driving.... cheers     Rate post 307281 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) the hole pattern On 8/28/2008 herbn wrote in from United States  (67.83.nnn.nnn) it's unusual strokerish two wide(normal) two closer but not excaliber narrow,newporter could be an excellent guess but perhaps wrong, maybe contineantal?     Rate post 307252 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) powers of observation On 8/28/2008 herbn wrote in from United States  (67.83.nnn.nnn) the brewer caught my attention,mine had white letters,but how about the trucks huh,i see a squareness a lock nut on the kingpin i eliminate tracker and cal slalom, metal base get rid of bennetts.they don't look like lazers, What does that leave? newporter?     Rate post 307251 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) wow On 8/27/2008 herbn wrote in from United States  (71.127.nnn.nnn) that blue brewer phantom,i special ordered on, it took months to show up,it was my first "dh" board with tracker fulls and roadrider sixes. I think i made skidplates out of it. ouch     Rate post 307220 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) OH MY GOODNESS #2 On 8/27/2008 Vintage Man wrote in from United States  (66.245.nnn.nnn) I AM STILL IMPRESSED WITH THIS COLLECTION and the condition of said Vintage Skateboards!!     Rate post 307216 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) A OH MY GOODNESS COLLECTION #1 On 8/27/2008 Vintage Man wrote in from United States  (66.245.nnn.nnn) I HOPE THIS COMES OUT PROPERLY AND YOU ALL CAN SEE THIS COLLECTION... IT WAS A OH MY GOODNESS COLLECTION TO ME.... I ONLY PUT UP 4 of the 20 pics. I UNDERSTAND IT TO BE IN EXCESS OF 300 SKATEBOARDS... OH MY GOODNESS :-----)     Rate post 307214 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) palce special On 8/26/2008 stewart savage wrote in from United Kingdom  (91.104.nnn.nnn) boyz if you remember my old board would kindly give away,set of lazers and that cheap deck me and sweeney had mine was yellow. its in mums garage at the moment     Rate post 307183 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) skaterboarder quaterly On 8/26/2008 hc wrote in from United States  (209.213.nnn.nnn) http://vintageskateboardmagazines.com/Quarterly_Skateboarder/QS_no2.html     Rate post 307174 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) G&S FreeRider On 8/22/2008 Dennis Allgeier wrote in from United States  (71.255.nnn.nnn) Brady-I got your e-mail and responded back to you but have not heard anymore from you. Did you get my e-mail about the board(s) you have or sale???     Rate post 307056 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0) G&S Freerider On 8/19/2008 Brady Mitchell wrote in from United States  (72.153.nnn.nnn) I have one for sale. It has early Trackers Racetracks with ABEC 11 Stingers. And get this, it has Larry Gordon`s and Debs signatures. I also have a prototype 2001 Teamrider with the Gullwing SL2001 slalom trucks and ABEC 11 No Skools. Email me.     Rate post 306916 ! Best-Of Ncdsa (0)   Informative (0)   Abuse(0)   Flag Moderators (0)

Posts 5453-5477 of 6027